Option Card Update History

825 Option cards cannot be updated automatically using the USB update pack. Except for the DLC card, firmware updates to the option cards require an ISP (In system programming) hardware interface and appropriate software to perform the update.

The DLC card may be updated using a PC connected to the card with a mini USB cable.

• Download the appropriate update zip file from the link below.
• Unzip the update package to a location on the PC such as Downloads.
• Power off the 825.
• Connect the USB cable to the PC and DLC card.
• Power on the 825.
• Run the 825DLC.bat file that was unzipped previously.
• If " ERROR " appears check that the USB cable is connected to the PC and option card. Power the 825 off, wait a minute, power on, then try again.
• The update will take several minutes. Do not disconnect until the "Press any key to continue..." display appears on the PC.

DAC (Digital to Analog)

Ver: 0.01.000 February 17, 2011

Original Release

DIO (Digital I/O Card)

Ver: 0.05.000

Added pulse/PWM output feature.

Ver: 0.04 May 13, 2010

Added counting feature.

Ver: 0.03 November 18, 2008

Initial release

DLC (Digital Load Cell Card)

​Ver: 1.00.001 October 29, 2018

Fixed issue that if previously configured for more cells, and then changed to fewer cells the calibration may not properly set zero.

Ver: 1.00.000 October 25, 2018

Initial Release

ICAN (ICAN Board)

Ver: 1.00 May 27, 2010

Original Release

SIB (Scale Interface Board)

Ver: 1.07.000 July 3, 2012

Changed version number to be consistent with new standard. Operation is identical to version 0.07 except for output of version information.

Ver: 0.07 May 6, 2011

Added FIR filter option. Break Range 0 = always on, Value 2 - 64.

Ver: 0.06 November 18, 2008

Clear weight average after calibration

Ver: 0.05 September 17, 2008

Changed default configuration parameters for board test.

Ver: 0.04 July 31, 2008

Added units labels to board parameters.