HDMI Output
The 825 Gen2 includes an HDMI output to connect a monitor or other display device.
There are three modes supported
LCD Only | LCD display active, HDMI output is inactive |
HDMI Only | LCD display is inactive - User interface is on HDMI output |
LCD and HDMI | User interface is on LCD, Apps may utilize HDMI output for display of images or video |
The 825 Gen2 display less model has no built-in LCD display. However, the initial software install sets the unit to LCD mode so it is necessary to change the unit to HDMI mode without being able to see the display.
- Plug in a USB keyboard to the 825 Gen2.
- Power on the 825 Gen2.
- After initial startup beeps and within five seconds press ALT-F5 on the USB keyboard. This initiates the display change mode. A sequence of beeps will sound to confirm the command was received.
- Press ALT-F8 within five seconds of hearing the response to ALT-F5. This specifies the desired display mode is HDMI. (Alternatively, ALT-F7 may be used to specify a change from HDMI back to LCD mode).
- Press ALT-F4 within five seconds of hearing the previous response. This saves the desired display change. A sequence of beeps will sound and then the 825 Gen2 will shutdown.
- Wait a minute after hearing the response to ALT-F4 and then cycle power to restart the 825 Gen2.
Last modified
8 weeks ago
Last modified on 09/18/24 13:14:45
Note:
See TracWiki
for help on using the wiki.