Changes between Version 32 and Version 33 of Docs/User/RemoteControl

Timestamp:

08/13/24 11:47:54 (3 months ago)

Author:

Don Wilson

Comment:

--

Docs/User/RemoteControl

@@ -3 +3 @@
 To enable remote control on an 825 indicator from the startup loader select "Legal metrology information / Setup", then "Setup menu". Select "Communication" then "Network". Select "Services". Make sure the "Remote Control" option is set to "Yes". Press ENTER to save changes.  
 
-To connect locally (from the same wired or wifi network) the remote desktop client will use the IP address that the 825 shows at the bottom of the "Application Menu". It is recommended to set the network router for "Static DHCP" (many routers use different terms for this) so that the 825 is always assigned the same IP address based on its MAC address. 
+Microsoft Remote Desktop client may be used to access the 825gen2. To connect locally (from the same wired or wifi network) the remote desktop client will use the IP address that the 825 shows at the bottom of the "Application Menu". It is recommended to set the network router for "Static DHCP" (many routers use different terms for this) so that the 825 is always assigned the same IP address based on its MAC address. 
 
 To connect from the public internet a VPN router may be configured or port forwarding may be used in the network router. (VPN is recommended because port forwarding may cause greater security risks). Consult your router documentation for how to do this. If port forwarding is used the client must use the public IP assigned by the internet service provider. This can be determined from a device with a web browser connected to the same network as the 825 by going to [http://www.whatismyip.com http://www.whismyip.com]