Changes between Version 29 and Version 30 of Docs/User/RemoteControl

Timestamp:

08/13/24 11:42:00 (3 months ago)

Author:

Don Wilson

Comment:

--

Docs/User/RemoteControl

@@ -1 @@
-== Remote Control ==
+== 825gen2 Remote Control ==
+
+To enable remote control on an 825 indicator from the startup loader select "Legal metrology information / Setup", then "Setup menu". Select "Communication" then "Network". Select "Services". Make sure the "Remote Control" option is set to "Yes". Press ENTER to save changes.  
+
+To connect locally (from the same wired or wifi network) the remote desktop client will use the IP address that the 825 shows at the bottom of the "Application Menu". It is recommended to set the network router for "Static DHCP" (many routers use different terms for this) so that the 825 is always assigned the same IP address based on its MAC address. 
+
+To connect from the public internet a VPN router may be configured or port forwarding may be used in the network router. (VPN is recommended because port forwarding may cause greater security risks). Consult your router documentation for how to do this. In this case the client must use the public IP assigned by the internet service provider. This can be determined from a device with a web browser connected to the same network as the 825 by going to [http://www.whatismyip.com http://www.whismyip.com]
+
+The 825 indicator is only accessible by remote control while in the application mode. Remote control may not be used for calibration/setup functions.
+
+== Legacy 825 Remote Control ==
 
 To enable remote control on an 825 indicator from the startup loader select "3. Legal metrology information / Setup", then "3. Setup menu". Select "2. Communication" then "1. Network". Make sure the "Web Server" and "Weight Server" prompts are set to "Yes". Press ENTER to save changes.  Press the left arrow three times to return to the main loader screen. Select "1. Application menu". From the "Application Menu" select "Configuration". Select "Configure Weight Server" then "Configure TCP/IP Server". If there is a "Num: 1" "Sc: 0" "Type: Custom" The weight server is already configured. Take note of the "Port:" number. If the "Num: 1" setting shows a different "Sc" or "Type" select it and change to "Scale: 0" and "Type: Custom". If there is not a "Num: 1" item select "* Add Server *" and create it.