Changes between Version 8 and Version 9 of Docs/825gen2/Dev/Devices/HDMI

Timestamp:

03/09/24 07:12:45 (9 months ago)

Author:

Don Wilson

Comment:

--

Docs/825gen2/Dev/Devices/HDMI

@@ -14 +14 @@
 2. Power on the 825gen2.
 3. After initial startup beeps and within five seconds press **ALT-F5** on the USB keyboard. This initiates the display change mode. A sequence of beeps will sound to confirm the command was received.
-4. Press **ALT-F8** within five seconds of hearing the response to ALT-F5. This specifies the desired display mode is HDMI. (Alternatively, ATL-F7 may be used to specify a change from HDMI back to LCD mode).
+4. Press **ALT-F8** within five seconds of hearing the response to ALT-F5. This specifies the desired display mode is HDMI. (Alternatively, ALT-F7 may be used to specify a change from HDMI back to LCD mode).
 5. Press **ALT-F4** within five seconds of hearing the previous response. This saves the desired display change. A sequence of beeps will sound and then the 825gen2 will shutdown.
 6. Wait a minute after hearing the response to ALT-F4 and then cycle power to restart the 825gen2.