Changes between Version 11 and Version 12 of Docs/825gen2/Dev/Devices/HDMI

Timestamp:

09/18/24 13:14:45 (8 weeks ago)

Author:

Don Wilson

Comment:

--

Docs/825gen2/Dev/Devices/HDMI

@@ -11 +11 @@
 The 825 Gen2 display less model has no built-in LCD display. However, the initial software install sets the unit to LCD mode so it is necessary to change the unit to HDMI mode without being able to see the display.
 
-1. Plug in a USB keyboard to the 825gen2.
-2. Power on the 825gen2.
+1. Plug in a USB keyboard to the 825 Gen2.
+2. Power on the 825 Gen2.
 3. After initial startup beeps and within five seconds press **ALT-F5** on the USB keyboard. This initiates the display change mode. A sequence of beeps will sound to confirm the command was received.
 4. Press **ALT-F8** within five seconds of hearing the response to ALT-F5. This specifies the desired display mode is HDMI. (Alternatively, ALT-F7 may be used to specify a change from HDMI back to LCD mode).
-5. Press **ALT-F4** within five seconds of hearing the previous response. This saves the desired display change. A sequence of beeps will sound and then the 825gen2 will shutdown.
-6. Wait a minute after hearing the response to ALT-F4 and then cycle power to restart the 825gen2.
+5. Press **ALT-F4** within five seconds of hearing the previous response. This saves the desired display change. A sequence of beeps will sound and then the 825 Gen2 will shutdown.
+6. Wait a minute after hearing the response to ALT-F4 and then cycle power to restart the 825 Gen2.