= USB Hub / Network Adapter = Tested a USB-C hub/Ethernet adapter connected to an 825gen2. [[Image(usb_hub_nic.png)]] Using an SSH or serial console connection to the 825 the ifconfig command may be used to view network status. {{{ card825gen2:~$ ifconfig eth0: flags=4163 mtu 1500 inet 10.1.2.230 netmask 255.255.0.0 broadcast 10.1.255.255 inet6 fe80::e85e:dbca:f02a:cc06 prefixlen 64 scopeid 0x20 ether f8:dc:7a:9e:53:0c txqueuelen 1000 (Ethernet) RX packets 11334 bytes 830538 (811.0 KiB) RX errors 0 dropped 1 overruns 0 frame 0 TX packets 163 bytes 21956 (21.4 KiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 eth1: flags=4099 mtu 1500 ether 00:e0:4c:68:0d:29 txqueuelen 1000 (Ethernet) RX packets 0 bytes 0 (0.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 0 bytes 0 (0.0 B) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 lo: flags=73 mtu 65536 inet 127.0.0.1 netmask 255.0.0.0 inet6 ::1 prefixlen 128 scopeid 0x10 loop txqueuelen 1000 (Local Loopback) RX packets 98 bytes 9285 (9.0 KiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 98 bytes 9285 (9.0 KiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 }}} "eth0" is the built-in network adapter. "eth1" is the USB adapter. Verified hub ports and Ethernet work. The setup app is updated to allow configuration of the secondary network adapter. [[Image(setup_network.png)]]